|Group||Pre-heating solar water heater|
|Min. Order||1 set|
|Terms of Payment||L/C, Western Union, T/T|
|Warranty time||3 Years|
|Deliver Time||5-15 working days|
|Brand||A-sun,OEM &ODM are acceptable|
|Life time||15 years|
|Material||Zinc coating steel or Stainless steel|
|Capacity||100 - 360 liter|
|Trade Term||FOB,CNF &CIF|
Pre-heating Solar water heater
|Feature||1. the cooper coil inside of the non-pressure tank can bear the pressure 0.7 Mpa during the operation.|
2. there is feeder tank which can load the water automatically.
3. the vacuum tube heat the water and supply hot water to the tank, then the water in the copper coil can be heated by the hot water in the water tank.
4. it is pre-heating and heat exchange process.
5. only if the water in the tank is hot, more hot water will be got and exceed the capacity limit of the water tank.
6. clean hot water from the copper coil.
7. you can use the hot water inside of the copper coil or the hot water in the tank.
|Model||Pre-heating solar water heater|
SUS304-2B 0.40mm-0.5mm,applies tig welding, the most advanced technology from South Korea.Inner tank is
produced with longitudinal welding,which anti-leakage and anti-rust for more using life
|Bath application||2-10 people|
|Outer tank||Zinc steel painted plate or stainless steel plate ,anti-corrision and anti-oxidation|
|Insulation layer||Imported PU layer 50-55mm with computer foaming,with 24 hours ripening process,and heat insulation material ACIR|
Upper air vent hole,side prepared hole,side temperature sensor hole,lower inlet,electrical heater hole,diameter
of water tank is 460/470/480mm
Zinc steel painted plate with width 10cm and thickness1.5mm,or stainless steel with width 10cm and thicknes
s 1.2mm,angle 27/38/45,which defend against typhoon
|Vacuum tube||Three target vacuum tube，with CU/SS-ALN coating film have high performance of absorb and low reflection ratio.|
|Fastener||Stainless steel screw|
|Silicon ring||High polymer silicon rubber|
|Copper Coil||Diameter 12mm ×25-30M|